Magnet is a fashionable headphone wire management solution - Great add-on to IPods, MP3´s and mobile devices headphones.

Magnet is a patented product that is the ultimate management solution to tangled cords. It is a two piece unit, using magnets which you can fasten to almost any clothing solving the "to long - messy wires" problem. The fashionable solution keeps the wire close to your body, eliminating headphone yank and pull.

The wire solution product is so easy in use. Simply slide the magnetic yo-yo-ish unit apart, place the front bit on your shirt and secure it in place with the back bit. Wind any excess cable into Magneat’s hidden clutches.

Magneat core benefits are the following; Cord management that guarantees no more messed up wires. Weight reduction, adds comfort to your ears. Magnet is easy to storage when not in use. The product offers great protection and adds life to earphones. The solution is easy attachment to clothing and other locations and is collectable and fashionable.

Magneat is ideal design product for: Commuters, Joggers, Gym bunnies, Cyclists, Musicians, Skateboarders, Fashionistas, Collectors and anyone else who loves music but hates dangly wires. Magneat is a great gift, an add-on to headphone’s IPods, MP3´s and mobile / device purchases.

Close



Watch the demo video,
"How it works" on our front page.

#1 While wearing your headphones, position the Magneat ideally around the point where the headphone-wire splits.


#2 Seperate the rear unit from the front unit by sliding apart. Place the front unit on desired position and the rear unit on the inner side of the garment. The rear unit will then attach itself, securing the Magneat.


#3 Connect the headphones to your device and place it in your pocket for example. Ideally remove headphones from your ears while doing this.


#4 While supporting the cord at the end closest to the device, start winding the cord onto the Magneat making sure you have adequate slack on the cord so as not to cause pulling while you are moving, as that could cause the jack to become unplugged.


#5 Now you are ready to put on your headphones and try out for comfort. If the headphones pull on your ears, wind back some cord until they do not. If there is still excessive cord, wind further.


When the cord has been adequately shortened, lock the cord by inserting in the slot-opening of the front unit.